Version 1.0, August 31, 2001, Copyright, Hugh Jack 1993-2001

16.2 PRACTICE PROBLEMS

 

1. A stepping motor is to be used to drive each of the three linear axes of a cartesian coordinate robot. The motor output shaft will be connected to a screw thread with a screw pitch of 0.125". It is desired that the control resolution of each of the axes be 0.025"

  1. a) to achieve this control resolution how many step angles are required on the stepper motor?
  2. b) What is the corresponding step angle?
  3. c) Determine the pulse rate that will be required to drive a given joint at a velocity of 3.0"/sec.

 

2. For the stepper motor in the previous question, a pulse train is to be generated by the robot controller.

  1. a) How many pulses are required to rotate the motor through three complete revolutions?
  2. b) If it is desired to rotate the motor at a speed of 25 rev/min, what pulse rate must be generated by the robot controller?